About

Repairing a hashboard often means guessing which chip is bad. PULSE V1 stops the guessing.

Plug in the hashboard and your bench PSU. PULSE V1 tests the chips and shows you, by number, which ones to replace. When the result is not clear, it says INCONCLUSIVE instead of guessing. After the repair, test again and see every chip pass.

PULSE V1 is made to be used through its web UI, which has more test features. Open the web UI in a browser on any phone, tablet or computer. Connect through PULSE's own WiFi hotspot, or plug a network cable into its Ethernet port. You can also use PULSE V1 on its own touch screen.

What PULSE V1 can do

• EEPROM editing
• Hash test at the frequencies you choose, with results in seconds
• Online firmware upgrade from the browser
• Temperature-sensor circuit repair mode
• Separate checks of the temperature sensors and the EEPROM address lines, to make repairs easier
• Chip map, chip count, and a temperature map and thermal soak for hydro boards
• Highly customizable, with advanced test modes for Bitmain hashboards

Important: PULSE V1 works only with Bitmain Antminer hashboards that use the 18-pin connector. Other brands are not supported. It tests ten Antminer S19 and S21 board models today: see the supported boards list. New boards come in firmware updates.

The "V1" in the name is the tester itself (the hardware), not a firmware version. Firmware updates do not change the name.

PULSE V1 is designed and built by Expert Solutions in India. It comes in four colours: Blue, Gray, Yellow and Red.

Questions? Visit our Contact page or message us on WhatsApp: +91 83207 81989.